To connect a router to a fiber optic cable, you need an Optical Network Terminal (ONT) to convert the fiber signal into Ethernet, which then connects to your router's WAN port.

Required Equipment

• Optical Network Terminal (ONT): Provided by your ISP, it converts optical signals into electrical signals your router can use .
• Fiber optic cable: Usually single-mode with SC/APC or SC/UPC connectors .
• Ethernet cable: Cat6 or higher recommended for high-speed data transfer .
• Router: Ensure it supports gigabit speeds or higher to fully utilize fiber internet .

Step-by-Step Connection

1. Locate the fiber wall outlet: This is where your ISP's fiber line enters your home .
2. Connect the fiber optic cable to the ONT: Remove protective caps, align the connector, and insert it into the ONT's optical port until it clicks securely . Handle the fiber carefully to avoid dirt or damage .
3. Power on the ONT: Wait 2–5 minutes for the status lights to stabilize .
4. Connect the ONT to your router: Use an Ethernet cable to link the ONT's Ethernet/LAN port to the router's WAN or Internet port .
5. Power on the router: Wait for the router's indicator lights to confirm a successful connection .
6. Configure the router: Access the router's admin panel via a web browser (commonly 192.168.1.1), input your ISP credentials if required, set up Wi-Fi, and secure your network with a strong password .

Tips for Optimal Performance

• Place the ONT close to the fiber entry point to minimize signal loss .
• Use high-quality Ethernet cables (Cat6a or higher) to maintain maximum speeds .
• Avoid bending or stressing the fiber cable, as it is sensitive to damage .
• Run a speed test after setup to verify your connection and ensure the router is properly configured . Following these steps ensures a stable, high-speed fiber internet connection from the fiber optic line to your home network.